For some time I have been trying to engrave something and then cut out afterwards. With previous software and machines, it was a case of making various layers visible or invisible. However, yesterday I got it cracked with this machine and the Corel software.
I put the engrving/marking on one page in Coreldraw and the cutting on a different page. Then I ran the engraving, then ran the cutting after the engraving had finished and hey presto, success.
Shortly after, the fuse went on the machine and everything stopped.This time I knew how to change the fuse and a few minutes later the machine was working again. It doesn't inspire confidence for the machine to blow fuses occasionally. So while the machine is cheap, I would say if you were thinking of getting one make sure that you have a warranty that actually is effective. <the crew I got this machine from are useless and had no interest in solving the very real problems that existed.
I put the engrving/marking on one page in Coreldraw and the cutting on a different page. Then I ran the engraving, then ran the cutting after the engraving had finished and hey presto, success.
Shortly after, the fuse went on the machine and everything stopped.This time I knew how to change the fuse and a few minutes later the machine was working again. It doesn't inspire confidence for the machine to blow fuses occasionally. So while the machine is cheap, I would say if you were thinking of getting one make sure that you have a warranty that actually is effective. <the crew I got this machine from are useless and had no interest in solving the very real problems that existed.
No comments:
Post a Comment